There are lots of ways to achieve faux tile effects. this is one of them. I stamped a daffodil stamp (from Rubbadubbadoo) onto white card, cut it into four. I then stuck onto a backing square of white card in with a little gap between each tile, using fairly thin foam tape. Finally I dabbed Versamark over the tiles (being careful not to drag it and risk smudging the ink below), and added a couple of coats of clear UTEE. I was quite pleased with the result but when I do it next time I will use thicker card. There was a lot of fiddling with heat to the front and back of the panel to make it lie straight. (This might also have been because the card was a bit damp to start with).
No comments:
Post a Comment